3
.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
1. Plug the Power Strip into a standard grounding duplex wall receptacle. Ensure that there are noexposed conductors.
2. Make sure electronic equipment is turned off before plugging into the surge protector outlets. Do not use extension cords
to connect equipment to the Power Strip.
3. Move power switch to “ON.” Your stripe unit should be providing surge protection. Check indicator light(s) periodically (see
note). The glowing stripe indicator light shows that stripe protection is being provided.
4. Connected equipment can now be turned on.
5. The association group supports
fi
ve nodes and life line function
NOTE:
Check the blue “Protected” light periodically. A glowing blue indicator light shows that stripe protection is being
provided. If the blue “Protected” indicator light stops glowing, the stripe protective components have expired and will no
longer provide surge protection. In this event, the Connected Equipment Warranty is no longer valid and the stripe
protector should be replaced.
TO return your switch to factory default:
1. If plugged in, unplug the smart switch from the receptacle.
2. Press and hold the top button for at least 3 seconds while you plug the smart switch into a receptacle.
1. Follow the instructions for your Z-Wave certi
fi
ed controller to include a device to the Z-Wave network.
2. Once the controller is ready to include your device, press up and release the toggle to include it in the network.
3. Once your controller has con
fi
rmed that the device has been included, refresh the Z-Wave network to optimize
performance.
4. The device is associated in the same group when it included in setting process. Now you can control your Z-Wave
device according to groups, scenes, schedules and automation programmed. If your controller features remote
access, you can now control all devices in Z-Wave network from mobile devices.
To exclude and reset the device
1. Follow the instructions for your Z-Wave certi
fi
ed controller to exclude a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, press up and release the toggle to exclude it from the network.
Our product can be included and operated in Z-Wave network with other certi
fi
ed devices and/or other applications.
All non-battery nodes within Z-Wave network will act as repeaters.
Power Strip — Limited Lifetime W arranty
Show Home Products Company warrants this Power Strip to be free of defects in workmanship and/or materials
for the life of the Power Strip. If such a defect should arise during the life of the Power Strip, Show Home Products
Company will, at its option, either repair or replace the Power Strip without charge. This warranty does not cover damage
caused by lightning, accident, misuse or alterations to the Power Strip.
This Power Strip, like all surge protectors, has a
fi
nite lifespan. Even under normal circumstances and in the absence of
defects, the product’s life will expire when the Power Strip’s component capacity has been exceeded,
thereby ceasing to provide protection from strips.
Important safeguards
Guarantee
ADDING TO Z-Wave
NETWORK
Plug ZW1502 into a wall outlet, press ZW1502 button (corresponding to the position of the socket), LED indicator light will turn
on, press the button again, LED off, output turn off.
the master controller enters the "Add Mode" , press the button ZW1502, let ZW1502 added into the home center;
Outlet
Power ON/OFF
Key LED
The main controller can control the first and second outlet socket output. When registration is by the home center(open and closed).
Adding device to Z-Wave network:
