SL STRIP 10IP LED Luminaire
2
QuickStart Guide
About Quickstart Guide
This Quickstart Guide is intended for a knowledgeable user to
unpack
,
install
,
and use SL
STRIP 10IP LED
Luminaires in a short time
period
.
For
the
complete
manual in PDF format
,
please visit our web site at
:
www.philips.com/showline
and click the user manual download link on the
product page
.
The
complete
manual
provides you all information
related
to
accessories
,
menu structures
,
DMX channel mapping
/
modes
,
and
care
for
your new luminaire
.
Included Items
Each SL STRIP 10
IP LED Luminaire includes the following items:
Figure 1
-
1
:
Included Items
Warnings and Notices
When using electrical equipment
,
basic safety
precautions should
always
be
followed including
the
following
:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
.
D o n o t mount near gas or electric heaters.
E q u i p ment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
T h e u se of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
D o n o t use this equipment for other than intended use.
R e f e r service to qualified personnel.
SAVE THIS DOCUMENT FOR FUTURE REFERENCE! READ COMPLETELY BEFORE INSTALLING AND USING PRODUCT!
WARNING
:
You
must
have
access
to
a
main
s
circuit
breaker or other
power
disconnect device before installing
any
wiring
.
Be
sure that
power is disconnected by removing fuses or turning the main circuit breaker off before installation. Installing the device with power on may
expose you to dangerous voltages and damage the device. A qualified electrician must perform this installation.
WARNING:
Refer to National Electrical Code
®
and local codes for cable specifications
.
Failure
to
use proper cable can result in damage
to
equipment or danger to personnel
.
WARNING:
This equipment is intended for
installation
in
accordance with
the
National
Electric Code
®
and
local regulations
.
It
is
also
intended
for
installation in indoor applications
only
.
Before any
electrical work is performed
,
disconnect power
at
the
circuit
breaker or
remove the fuse to avoid shock or damage to the control. It is recommended that a qualified electrician perform this installation.
Service and Maintenance
For all service and maintenance issues, please contact your local Showline office or an Authorized Service Center.
Power Requirements
The SL STRIP 10
IP LED Luminaire operates on AC input voltages from 110 to 240 VAC.
WARNING: This unit does not
contain
an ON
/
OFF
switch
.
Always disconnect
power input cable
to
completely
remove
power
from unit
when
not
in use
.
AC Power
Operation
When
connected
to
an
AC
source
,
the unit
operates on
110
to
240
volts
AC
(+/-
10
%,
auto
-
ranging
).
The
luminaire contains an
auto
-
ranging
power supply
.
Each luminaire
can
draw
up
to
150
Watts
.
SL STRIP 10
IP LED Luminaire
QuickStart Guide
(
this
document
)
SL STRIP 10
IP LED L
UMINAIRES
Q
UICK
S
TART
G
UIDE
