11
Ordercode: 40312
LED Aircone DMX
DIP switch setting for DMX Mode
DMX products must have their own unique address to receive DMX signals.
Addresses on the LED Aircone DMX are set by flipping the appropriate DMX DIP switches.
You need to know that DMX address settings are the sum of the DIP switch values.
A standard DMX address for a Showtec LED Aircone, which has 6 channels is as follows:
Example 1
LED Aircone
Address Value
DMX DIP Switches "ON"
Unit 5
25
#1 , #4, #5
Switch
Value
#1
1
#4
8
#5
16 +
Total sum
25
Explanation: Since each unit has 6 channels, each address advances 6 values (See Address Value
above).
Once address values are determined, add DMX dip switch values to obtain the appropriate address
(DMX Dip Switches "ON") for each unit. Flip appropriate DMX dip switches on each unit.
Example 2
02)
If you want to give a LED Aircone a DMX address 133, you first have to find the number 133 in the
DMX Address Quick Reference Chart (see page 12).
03)
Then look at the left side (DIP Switches #1-#5) horizontally from 133.
In the table you will see that #1=ON, #2=OFF, #3=ON, #4=OFF, #5=OFF.
04)
Finally, look at the upper side of the table (DIP Switches #6-#9) vertically from 133.
In the table below you will see that #6=OFF, #7=OFF, #8=ON, #9=OFF.
