8
Order code: 75132
Multigrip Clamp
Installing the Multigrip Clamp onto Flat Surfaces
It is possible to install the Multigrip Clamp onto flat surfaces by means of the included wedge (04).
01)
Turn the spigot mounting screw (05) counterclockwise until you remove it.
02)
Remove the wedge (04) located under the spigot mounting screw (05).
03)
Insert the wedge (04) into the mounting holes on the Multigrip Clamp.
Fig. 05
04)
Turn the mounting screw (01) counterclockwise, to loosen the jaw of the Multigrip Clamp.
05)
Mount the clamp onto a flat surface.
06)
Make sure that the surface does not exceed the recommended size: 10–55 mm.
07)
Turn the mounting screw (01) clockwise, to tighten the clamp and fit it firmly to the surface.
Fig. 06
Summary of Contents for 75132
Page 14: ...13 Order code 75132 Multigrip Clamp Notes ...
Page 15: ...14 Order code 75132 Multigrip Clamp ...
Page 16: ... 2020 Showtec ...