22
Creator Compact
Ordercode: 50729
10 Maintenance
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
1)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
2)
There may not be any deformations on housings, fixations and installation spots.
3)
Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
4)
The electric power supply cables must not show any damages or material fatigue.
The
Showtec Creator Compact
requires almost no maintenance. However, you should keep the unit
clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections
with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying
electric power.
11 Q/A
Q: Way the dimmer level does not adjust by the playback slider, and turn to 0 after Clear?
A: Has the dimmer channel been configured? If not, the dimmer channel will not adjust by playback
slider and turn to 0 after double click <Clear> button. To configure the dimmer channel:
Enter Program Mode. Press <Patch> to enter Patch Menu. Select a desired fixture and push the slider of
the dimmer channel till its value in the screen shows [Dimmer].
Q: I don’t need dimmer data save in a playback
A: In playback editing, after the dimmer slider is set to a desired brightness, if you don’t want to save the
dimmer in the data, you can follow the below steps to remove the dimmer channel from the playback:
Enter Program Mode. Select the desired fixture. Press <Clear> to enter Clear Menu. Push the dimmer
channel to any position. Press <Exit> to exit. Now, you can see that the dimmer channel is not ON in the
screen. After, keep on your playback editing and select “Record by Channel” when saving the
playback. Then, the dimmer will not be included.
