7
Backside
Fig. 2
3 4 5 6
3)
DMX signal connector (OUT) 3-pin
4)
DMX signal connector (IN) 3-pin
5)
IEC power con Fuse 3,15A 250V
6)
On/Off
Installation
Remove all packing materials from the
Indigo 4500 LED
. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be music-controlled by its built-in
microphone.
Control Modes
There are 4 modes:
• Stand-alone (built-in programs)
• Sound-controlled
• Master/Slave
• DMX512 (14 Channels ADVANCED or 11 channel BASIC)
One Indigo (
Built-in Programs
)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the Indigo is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 13 for more information about the built-in programs.
One Indigo (Sound-control)
1.
Plug the end of the electric mains power cord into a proper electric power supply socket.
2.
Turn on the music. If the device is set to sound-control, then the Indigo will react to the beat of the
music.
Please see page 13 for more information about the sound-control options
.
Summary of Contents for Indigo 4500 LED
Page 1: ...Indigo 4500 LED ORDERCODE 41382 ...
Page 23: ...21 Channel settings Beam Angle Fig 6 ...
Page 30: ......
