2. Operation Guide
2. Operation Guide
2.3.4 Delete a Chase
2.3.5 Delete all Chases
2.4 Running Scenes
2.4.1 Manual Mode
2.4.2 Auto Mode
1. Select the chase you wish to delete.
2. Press and hold down the Auto/Del button.
Tap the Chase button while holding down the
Auto/Del button, all LEDs and the Segment
Display will flash three times briefly indicating
this chase has been deleted.
1. With the power off, press and hold down the Auto/Del
and Bank Down buttons at the same time.
2. Apply the power again.
SCENE
Auto/Del
4. Tap the Scene button to select the scene
to run.
1. When the power is turned on, this unit enters Manual mode automatically.
This function allows you to run a bank of programmed
scenes in a sequential loop.
2. Make sure Auto trigger and Music trigger indicators in the Segment Display are
both off.
3. Use the Bank Up/Down button to select the bank that contains the scenes you
wish to run.
1. Tap the Auto/Del button to activate Auto mode.
A highlight next to "Auto trigger" will indicate
Auto mode.
22
21
Chase Button 1-6
Chase
Auto/Del
Auto/Del
BANK
