8
Installation
Remove all packing materials from the Sunstrip Active. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Installing the Lamp
The Showtec Sunstrip Active uses the Halopar 16, GU10 230V/50W 35° (ordercode
) bulb as
manufactured by all popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage
! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure
1.
Loosen the 4 screws on the front of the housing.
2.
Gently remove the metal housing.
3.
Read lamp instructions. Do not touch the lamp bulb glass. Push and turn the lamp Counter Clockwise
and remove the lamp. Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the
glass with a clean, lint-free towel and rubbing alcohol.).
4.
Insert the lamp pins into the small holes in the lamp socket. Push and turn Clockwise to install the
lamp. Do the same for the remaining lamps.
5.
Put the metal housing back and fasten the screws snugly.
Fig. 3
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Damages caused by non-observance are not subject to warranty.
Summary of Contents for Sunstrip Active MKII
Page 1: ...Sunstrip Active MKII ORDERCODE 30714 ...
Page 22: ......
