Advanced flight function
Speed gear adjustment
Press the No.4 key on the remote control unit to change the speed of drone. When the
drone is switched into low speed gear, the remote control unit will make a beep sound,
when the drone is switched into high speed gear, the remote control unit will make two
beeps. The speed gear will be kept in low speed gear automatically after the drone or
battery power of remote control unit is shut down and restarts again.
Photographing and video recording
Short press the No.5 key on remote control unit, the remote control unit will make a
short beep and then begin to take pictures; long press the No.5 key on remote control
unit, the remote control unit will make a long beep and then begin to record a video,
long press again to terminate the recording. The camera and video documents that
are recorded will be saved in the mobile that is connected with drone, you can read
them directly in the control software.
Note: This feature is only available when the phone is connected.
One-click return
Altitude hold mode (indoor mode, please use it cautiously)
Each time, when the drone takes off, the Global Position System of the drone will
automatically remember the takeoff point. When you press the No. 6 key on the
remote control unit in the flight, the remote control unit will make continuously beeps,
and the drone will automatically return to the takeoff point. If you press this key again
when the drone is on the way back, the drone will stop returning back and keep
hovering.
After calibrating the gyroscope and headless flight direction, you can press the No.11 key on the remote control unit to turn off the
GPS, the drone can be started up and fly under situation of unfinished satellite positioning (or in indoor environment). You can
press this key again; the remote control unit will make a long beep to restart the GPS.
Note:
①
If you turn off the GPS in indoor environment, the drone can take off, but it is easy to be disturbed by indoor radio signals, which
may cause the drone to lose control and hit indoor persons or articles. Please use this function cautiously.
②
When the outdoor wind is strong, it is not recommended to open the altitude hold mode, which will cause the wind resistance
ability of the drone dropping, the drone can be blown away by the wind.
3 Do not use altitude hold mode in the air to conduct satellite positioning, the return point will be on the ground below the position
vertically, which may cause the drone to misjudge the return point. If you want to switch back GPS mode from the altitude hold
mode, please take back the drone and place it on the ground, then restart the GPS (press No. 11 key again) and the motor.
Safety Measures
1. Signal loss protection Signal loss protection means that the drone will automatically return to the takeoff point if it has
successfully searched satellites and positioned before taking off, and kept the GPS turning on after losing the remote control signal.
Drone will run Off Signal Safe Mode in following cases:
①
Remote control loses power or is shut down suddenly.
①
Disconnect mobile's wifi, exit related software, power off, etc. if the drone is controlled by a phone
③
Remote control signal or mobile phone signal is interfered by other electromagnetic wave.
④
Drone is beyond the effective distance of remote control signal or mobile phone wifi signal due to wind or inertia reason.
⑤
There is an obstruction between the drone and the remote control unit or mobile phone to affect the signal transmission.
2. Low battery protection Low battery protection means that the drone has a smart power calculation system, which can calculate
the flight time based on the flight speed and remaining power, when the remaining power is lower than protection value, the drone
will automatically return to the safe range, when the remaining power is nearly exhausted, the drone will automatically return to the
takeoff point and force to land. When the drone is with the low battery protection mode, the four indicator lights will flash
simultaneously. It is recommended that you purchase more spare batteries and charge the batteries before using to ensure
sufficient power.
The remote control unit also has the low battery protection function. When the remote control unit is with the low battery protection
mode, it will continuously make beeps to remind. At this time, you should take back the drone and replace the remote control
batteries.
3. Emergency stop When the drone is out of control or in an emergency: winding with branches, wires, hair, etc., or when the
blades hit an obstacle, the drone will automatically enter the emergency stop mode and shut down. When the outdoor wind is
higher than level 5 or strong gust, the drone will also enter this mode. In the event of other emergency situations, the drone motor
has not be shut down, you should refer to the one-click stop function to shut down the motor. Note: In this mode, the drone will fall
from the air, it may be destroyed and hurt people and animals below, so please ensure that the flight environment and operation
methods meet the safety conditions. You can use the "one-click landing" function as appropriate.
