Shred Emulsifier SE1-PRO, Owner'S Manual

4

Important Safeguards (continued)

•  Never use hands, fingers, or other utensils to insert food into the Pitcher. Use the Tamper only.

• Never leave the 

Shred Emulsifier

TM

 unattended while motor is running.

•  Never add ingredients to the 

Shred  Emulsifier

TM

 while unit is running at a speed greater  

than #1.

• We do not recommend RUNNING the unit when the Pitcher is empty.

• Always hold the Pitcher handle when operating this unit at high speeds.

•  Never put fruits with pits in the 

Shred Emulsifier

TM

. Remove pits prior to placing these items 

into the Pitcher.

• The maximum Pitcher capacity is 70 ounces. Use significantly less with thicker ingredients.

•  When processing foods with a dense consistency such as peanut butter, grains, or doughs, do 

not process for more than 30 seconds at a time. Doing so can cause the motor to overheat.

• Always make sure the Lid and E-Z Lock Cap are positioned and secured properly before use.

•  Do not let cord come in contact with a stove, other hot surfaces or hang over edge of a table  

or counter.

•  Close supervision is necessary when any appliance is used by or near children.

•  Keep hands and utensils out of container while blending to reduce the risk of severe injury 

to persons or damage to the 

Shred Emulsifier

TM

. A scraper may be used but must be used  

only when the blender is not running (does not apply to an acceptable scraper integral with  

the appliance).

•  Always operate blender with cover in place.

•  Do not immerse in water.

•  Never place blade assembly on base unless assembled to container.

               WARNING: Failure to follow these instructions can result in death,

               fire, or electric shock.

SPECIFICATIONS: 

Model: SE1-PRO

 - 120VAC 60Hz 1500W

Caution: Avoiding Serious Injury and Burns While Processing Hot Liquids

•  Make sure the Lid and E-Z Lock Cap are properly positioned and secured when processing 

hot liquids.

•  When processing hot liquids always start on lowest speed (“STIR” on LED Display). Then 

increase rapidly to the required speed for that recipe. Use caution when working with hot 

liquids as steam may escape from the safety vents on the sides of the E-Z Lock Cap.

• Always hold the Pitcher securely by the handle while processing hot liquids.

SAVE THESE INSTRUCTIONS