Shred Emulsifier SE1-PRO, Owner'S Manual

6

Assembling the Shred Emulsifier

TM

Unwind power cord to desired length.

This  appliance  was  designed  with  built-in  power

cord storage beneath the Base. Store the excess

length of cord neatly underneath to avoid accidental 

tipping of machine while in use.

WARNING:

 Do not plug power

cord into electrical outlet until unit

is fully assembled.

Power to unit will not take place unless steps 1–5 

in this section are followed carefully.

1. Place the motor Base on a stable, dry surface.

2.  

Firmly seat the Pitcher onto the Base. The 

Pitcher will fit on the Base 4 different ways. The 4 

protrusions on the Base should fit into the corners 

under the Pitcher. Once seated properly, this will 

activate the weighted safety switch.

NOTE:

At this point you may want to place the ingredients 

for processing into the unit. Add ingredients into the 

Pitcher,  soft  foods  first,  harder  items  last.  The  E-Z 

Lock Cap can be removed during operation to add 

additional ingredients or to insert the Tamper. The E-Z 

Lock Cap should only be removed at the lowest STIR 

speed  setting. Always  replace  E-Z  Lock  Cap  when 

you are finished using Tamper or adding ingredients.