9
SHENZHEN SHUNXUN ELECTRONICS CO.,LTD
www.foxun.com
120m HDMI Extender over Ethernet, with RS232, POE, IR
Setup HDMI TX and HDMI RX
A HTTP server is embedded in each TX and RX. you can setup IP address for HDMI extender via web
browser.
The default IP address of the TX is 192.168.168.55, MAC address is: 00:0b:78:00:60:01.
The default IP address of the RX is 192.168.168.56, MAC address is: 00:0b:78:00:60:02.
Step 1:
→
Assign the PC (or laptop) IP address on the computer : “Control Panel” ” Network
→
→
→
Connections” “Local Area Connections Status” “Properties” “Internet Protocol (TCP/IP)”, Type the IP
address field with 192.168.168.11 (0-255) and Subnet mask with 255.255.255.0. After that press OK
to save the configuration.
Note: The IP address of PC should be different from the IP address of TX and RX.
Step 2: Use an Ethernet Cable to connect the PC (or laptop) and the extender. the power LED for the
extender is red and the status LED becomes green.
Step 3:
→
→
please Ping the connected device through the sequence on computer: “Start” “Run” input
→
“CMD” input “ping 192.168.168.55” for TX or input “ping 192.168.168.56” for RX, you will receive
the reply if the connection is established.
Step 4: Login in the IP adress :192.168.168.55 (default IP for TX) or 192.168.168.56(default IP for RX),
You can setup IP address, subnet mask, gateway, and MAC address for the TX and RX.
Please set IP address for each TX and each RX, IP:192.168.168.XX (XX:1-255. all IP address for TX and
RX must be different .
Please set MAC address for TX and RX, MAC:00:0b:78:XX:XX-XX (XX:01-FF), The MAC address for each
TX and each RX must be different .
Step 5: After click “Apply” button, the green LED light on the device will go out, you have successfully set
IP address for TX and RX now.
Note: if you need to restore the device to it’s factory default settings, please power on the device, the red
light becomes lighting, waiting about 10 seconds, the green LED light starts working, at this time to press
the reset button about 5-10 seconds, then the green light will go out, you have successfully restored IP
address to factory IP address now.
