Operating Instructions
4
Front Panel
Rear Panel
Power ON/OFF
Status indicator lamp:The LED will illuminate when the HDMI equipment is connected.
Power indicator lamp:The LED will illuminate when the power is
on.
Reset key
Power input port
1
3
2
4
RS232 port
Output2,3&4 port ( IR pass-though)
1
2
2
3
4
5
4
4
6
3
4
5
6
HDMI input port
Connecting and operating
1) Connect the HDMI input sources into HDBaseT splitte
r.
2) Connect HDMI receiver over Cat5e/Cat6 cables to both the Cat5e/6 port of HDBaseT Splitter
and Cat5e/6 port of Receive
r
,The RJ45 connections must follow EIA-TIA 568b standards.
3) Connect the HDMI output from the Receiver(RX) into the display HDMI input.
emitter onto the source IR windows
. .
5) Connect IR-RX cable into IR-RX port on the receiver and af
x the receiver on the display frame
/bezel or the display stand.
Note
：
Do not a x the emitter until the placement is tested.
6) Power up all units
,
the splitte
r
,Receiver
,
sources and displays.
Output1 port ( Ethernet,RS232&IR pass-though)
Ethernet port
