P/N 1808684 Rev. I
10
Pivot Arm Installation - Single Axle
STEP 1:
To determine assembled return arm length, measure
from pivot shaft to top rear corner of tarp housing side
plate. Subtract 4" from that measurement and cut
return arms to this length.
STEP 2:
Turn spring shaft (counter-clockwise on driver side
and clockwise on passenger side) until you feel shaft
contact hook on spring. Slide spring pivot connector
onto shaft so connector is close to horizontal.
assembled
arm
length
tarp
housing
pivot
shaft
STEP 3:
Slide return arm onto spring pivot connector. Align
outer profiles to match and let end of arm rest on
ground. Fasten return arms to spring pivot connectors
with screws
F
, washer
V
and nuts
P
as shown.
2
1
P
F
V
Item Part #
Description
1. 1800421 Aluminum Return Arm - Straight
2. 1801636 Spring Pivot Connector
F. 1800561 Pan Hd. Screw - 5/16" x 2 1/4"
V. 1800989 Flat Washer - 5/16"
P. 1800990 Lock Nut - 5/16"
spring
pivot
connector
spring
shaft
NOTE:
To continue installation, turn to Tarp Tube Assembly
& Tarp Installation on page 13.
F
V
P
return
arm
spring
pivot
connector