![background image](http://html.mh-extra.com/html/shur-co/donovan-quick-flip-iii/donovan-quick-flip-iii_owners-manual_1260973014.webp)
P/N 1808684 Rev. I
11
Pivot Arm Installation - Tandem/Multi-Axle Trucks
Item Part #
Description
1. 1800548 Upper Aluminum Arm
2. 1800547 Arm Coupler
3. 1800545 Lower Aluminum Arm
4. 1801636 Spring Pivot Connector
F. 1800561 Pan Hd. Screw - 5/16" x 2 1/4"
V. 1800989 Flat Washer - 5/16"
P. 1800990 Lock Nut - 5/16"
1
2
4
3
NOTES
: If holes will not align well enough to insert bolts, run
5/16" drill bit through holes. Place bolt heads on inside of
arms to prevent bolts from catching on container.
pivot
connector
spring
assembly
align
as
shown
&
tighten
screws
V
P
F
P
V
F
STEP 1:
Turn spring shaft (counter-clockwise on driver side
and clockwise on passenger side) until you feel shaft
contact hook on spring. Slide spring pivot connector
onto shaft so connector is close to horizontal, then
tighten screws.
STEP 4:
Slide arm coupler into
lower arm and fasten
with screws
F
, washers
V
and nuts
P
.
NOTE:
To continue installation, turn to
Tarp Tube Assembly & Tarp Installation
on page 13.
STEP 5:
Slide upper arm onto arm cou
-
pler and fasten with screws
F
,
washers
V
and nuts
P
.
V
F
P
V
F
P
arm
coupler
lower
arm
upper
arm
arm
coupler
F
V
P
lower
arm
pivot
connector
bend
in
arm
spring
assembly
STEP 3:
Slide lower arm onto pivot connector on spring as
-
sembly, positioning bend in arm as shown. Fasten
lower arm to pivot connector with screws
F
, washers
V
and nuts
P
.
STEP 2:
Mark and drill 5/16" holes in lower end of arm. Cut arm
to length before drilling holes if shorter arm length is
desired.
7 1/2"
6"
mark
&
drill
5/16"
holes