Shur-Co SMART3, Operating Instructions Manual

P/N 1126870 Rev. B

Wireless Remote Programming & Operating Instructions 

- continued

3

Receiver will accept and respond to signals from up to three 

remotes. Receiver will not respond to signals from remotes that 

have not been paired to it.

NOTE:

 Only SMART3™ remotes will function with 

SMART3™ receivers. The original SMARTtransmitter

®

 or 

™ cannot be used.

PAIRING (INTRODUCING) REMOTE(S) TO RECEIVER

red

led

light

programming

button

NOTE:

 Remotes are typically paired to receivers at factory if 

remote is shipped with receiver.

STEP 1:

Connect receiver to power.

 Make sure target re

-

ceiver is connected to 12-volt power supply. Keep 

remote within 20' of receiver during pairing process.

Option 1:

  On receiver, press and hold simultaneously both 

Open

and 

Close

 buttons on receiver. After three seconds, 

you will hear buzzer beep. Release buttons. Receiver 

is now in pair mode.

NOTE:

 When you press 

OPEN

 and 

CLOSE

 on receiver, you 

may hear a click from solenoid in receiver box, but outputs 

will not stay on while both buttons are held simultaneously.

NOTE:

 While in 

PAIR MODE

, receiver will not turn outputs on.

STEP 2:

Prepare remote.

 Open remote lid and use 

Select

 but-

ton to select desired channel on remote. Set remote 

aside, but do not close lid.

STEP 3:

Put receiver into pair mode.

STEP 4:

Put remote into pair mode.

 Pick up remote and press 

and hold simultaneously both 

OPEN

 and 

CLOSE

 but-

tons on remote. After three seconds, channel indicator 

light will go solid. Release buttons.

STEP 5:

Complete pairing.

 Remote will now pair to receiver. 

If pairing was successful, receiver buzzer will beep 

twice. Remote can now be used to control receiver.

If pairing was unsuccessful, receiver will time out of 

Pair Mode after 15 seconds and buzzer will beep 

once. Try again to pair.

STEP 6:

 Repeat process for any other remotes.

Option 2: 

Standard receiver boxes only: Remove eight screws 

holding plastic cover on receiver box. Pull cover off 

gently, but do not disconnect any wires. Press and 

hold programming button next to red light. Red light 

will go solid. After three seconds, light will start blink

-

ing and buzzer will beep. Release button. Receiver 

is now in Pair Mode.

select

button

open

button

close

button

receiver

mini

-

module

open

button

close

button