Shurco LITEALL SMART2 Remote, Owner'S Manual

P/N 1127747 Rev. A

7

Programming SMART2™ Remote

to Control Module

FIGURE 1

STEP 2:

  From Main Menu on SMART2™ remote, arrow to 

Setup

 option and press Select.

Pairing devices (introducing remote to LiteALL™):

Before  remote  can  operate  LiteALL™  module,  they  must  be 

paired, or introduced. If remote must be introduced to LiteALL™ 

module, or if second remote is purchased later, follow instruc

-

tions below:

MAIN MENU

SETUP

TARP

FRONT HOPPER

BACK HOPPER

NEW DEVICE

BACK TO SETUP

WAITING. . .

HOLD BUTTON ON

TARGET RECEIVER

FOR 5 SECONDS

TO PAIR DEVICE.

FIGURE 3

STEP 4:

  Remote will now be waiting for receiver to enter pairing 

mode.

FIGURE 2

STEP 3:

  Arrow to 

Add Device

 and press Select.

SETUP MENU

TO MAIN MENU

DEFAULT DEVICE

DEVICE ORDER

ADD DEVICE

EDIT DEVICE

DELETE DEVICE

INFORMATION

STEP 1.

  Make sure LiteALL™ control module is connected to 

power.

STEP 5:

On LiteALL™ control module, press and hold both 

OUTPUT A and OUTPUT B buttons for approximately 

six seconds.

NOTE:

 Refer to SMART2™ remote Owner's Manual for com-

plete remote instructions.

output

A

Button

output

B

Button