Shurco LITEALL SMART2 Remote, Owner'S Manual

P/N 1127747 Rev. A

8

STEP 6:

  Remote will confirm it has detected LiteALL™ module. 

Verify device type is LIGHT and press Select.

FIGURE 5

STEP 8:

  Remote will display INFO SAVED to confirm remote 

has been successfully introduced to LiteALL™.

STEP 9:

  Repeat steps 1 to 8 for any additional remotes to be 

programmed to LiteALL™ module.

Programming SMART

2™ 

Remote

to Control Module

 - continued

ADD NEW DEVICE

DEVICE FOUND

TYPE: LIGHT

ID: 0000008E

VERSION: 011

ADD DEVICE

CANCEL

NOTICE

If the device type is incorrect, call the Shur-Co

®

 Help 

Line. You can damage your system if you operate 
the wrong device-type receiver on your system.

!

STEP 7:

  You may rename device at this time, or it can be done 

later, if desired. If you choose to rename at this time, 

see section on renaming device in your SMART2™ 

remote Owner's Manual. If current name is accept

-

able, highlight 

Accept

 and press Select to continue.

FIGURE 6

CHANGE NAME

LGHT0000008E

ACCEPT

CANCEL

ABCDEFGHIJKLM

NOPQRSTUVWXYZ

0123456789<_

STEP 1:

  From main menu on SMART2™ remote, arrow to 

Setup

 option and press Select.

STEP 2:

  Arrow to 

Edit Device

 and press Select.

Setting operating mode (linked or unlinked outputs):

Using SMART2™ remote, you may link OUTPUTS A and B so 

they turn on or off together when using remote. This is referred 

to as LINKED MODE.
At any time, remote can be set to operate LiteALL™ module 

in LINKED or UNLINKED mode by following these instructions:

FIGURE 7

MAIN MENU

SETUP

TARP

FRONT HOPPER

BACK HOPPER

LIGHTS

FIGURE 8

SETUP MENU

TO MAIN MENU

DEFAULT DEVICE

DEVICE ORDER

ADD DEVICE

EDIT DEVICE

DELETE DEVICE

INFORMATION