7
ShowLink Access Point Overview
AD610
ShowLink
Acces Point
PUSH
௦
௧
௨
M6
① ShowLink 2.4 GHz detachable antennas
For 2.4 GHz signals
② ShowLink Data Status LED (blue)
- ON Steady: Linked, no data transmission
- Flashing: Transmitting data. Rate of flashing indicates level of activity
③ Power Status LED (green/amber/red)
- Steady Green: Power ON, power source = PoE
- Steady Amber: Power ON, power source = external power supply
- Red Flashing: Response to remote ID flash command
④ Ethernet Status LED (green)
- ON Steady: Ethernet connected, no traffic
- ON Flashing: Ethernet connected, flashing corresponds to volume of data
traffic
⑤ ¼"-20 threaded mounting point
Use to wall-mount the access point
⑥ External power supply connector
Connection point for external power supply
⑦ Reset button
Press to restore factory settings
⑧ Ethernet port
For network connection and Class 1 PoE
⑨ Scanning antenna for channel agility
Scans the 2.4 GHz spectrum for the best frequency
⑩ M6 x 1.0 threaded mounting point
Use to mount access point to safety cable
Features
• Real-time wireless remote control of up to 16 transmitters per ShowLink
access point
• New RF design and true diversity antenna scheme for improved link
performance
• Easy transmitter authentication—Recognizes linked transmitters upon
IR sync
• Provides coverage area approximately the same as the transmitter’s
range
• Automatic hand-offs between multiple access points extend operating
range
• Automated channel selection—Independently scans 2.4 GHz frequency
range and determines best channel for use
• Automatic frequency agility—Moves a ShowLink network to the best
available 2.4 GHz channel in the event of signal degradation
• Wireless Workbench 6 software supports networked control of all de-
vice functions and provides a ShowLink plot for viewing 2.4 GHz signal
levels
• Receives power via Power over Ethernet (PoE) network connection or
from an external power supply
• Versatile mounting options—Fits microphone stand adapters and has
built-in ¼"-20 and M6 x 1.0 threading for permanent installation
• Backwards compatible with Axient analog transmitters and receiver
AD610 ShowLink Access Point
The AD610 ShowLink™ access point enables real-time remote control of all ShowLink-enabled Axient™ transmitters, including both digital and analog
models. The access point allows comprehensive management of transmitter parameters from the receiver or Wireless Workbench
®
6 using 2.4 GHz
wireless network communication. All parameter changes occur without interruption to the performer.
Multiple access points can extend the operational range or increase the number of transmitters supported on the ShowLink network. The access point
features true diversity antenna inputs along with mounting points for ¼"-20 and M6 x 1.0 thread.
Included Components
Wireless microphone clip for mounting on a microphone
stand
WA371
Euro thread adapter for WA371
31A1856
Shielded 25-foot Ethernet cable for ShowLink access
point, RJ45-to-EtherCon connector
95A15104
Power supply (regionally dependent)
PS43
Optional Accessories
Directional 2.4 GHz patch antenna
AXT644 (available
depending on regional
regulations)
