- 70 -
Supervisor/User Password Setting
You can set either supervisor or user password, or both of them. The
differences between them are:
Supervisor Password and User Password
Supervisor Password and User Password
Supervisor Password and User Password
Supervisor Password and User Password
Supervisor Password and User Password
The options on the Password screen menu make it possible to restrict
access to the Setup program by enabling you to set passwords for two
different access modes: Supervisor mode and User mode. In general,
Supervisor mode has full access to the Setup options, whereas User
mode has restricted access to the options. By setting separate Supervisor
and User password, a system supervisor can limit who can change
critical Setup values.
Enter Password
Enter Password
Enter Password
Enter Password
Enter Password
Type the password up to eight characters, and press <Enter>. The
password typed now will clear any previously entered password from
CMOS memory. You will be asked to confirm the password. Type the
password again and press <Enter>. You may also press <Esc> to
abort the selection and not enter a password. To disable password, just
press <Enter> when you are prompted to enter password. A message
will confirm the password being disabled. Once the password is dis-
abled, the system will boot and you can enter Setup freely.
