- 13 -
Step 2
Set Jumpers
The default jumper settings have been set for the common usage standard of
this mainboard. Therefore, you do not need to reset the jumpers unless you
require special adjustments as any of the following cases:
1. Clear CMOS
2. LAN Enable/Disable
3. CPU Frequency Select
4. 5V/ 5VSB Select
For first-time DIY system builders, we recommend that you do not change the
default jumper settings if you are not totally familiar with the mainboard con-
figuration procedures. The factory-set default settings are tuned for optimum
system performance. For the advanced users who wish to customize their sys-
tem, section 3.2 Jumper Settings will provide detailed information on how to
configure your mainboard manually.
Step 3
Install DDR System Memory
To install memory, insert DDR-SDRAM memory module(s) in any one or two
DIMM banks. Note that SDRAM modules are directional and will not go in the
DIMM banks if they are not properly oriented. After the module is fully inserted
into the DIMM bank, lift the clips of both sides of the DIMM bank to lock the
module in place.
DDR SDRAM
