- 76 -
@
Set Password
This item is to set supervisor password. Please follow below steps.
New Password Setting :
1. While pressing <Enter> key to start setting password function, a
dialog box appears to ask you “Enter password: “.
2. Key in a new password now. However, the password can not be
over eight characters or numbers.
3. Then system will request you to confirm new password by asking
you to key in new password again.
4. Once the confirmation is completed, new code takes effect.
No Password Setting :
5. If you want to delete password, just press <Enter> key instead of
new password while password input is requested. And the other
procedures are the same as above password setting.
If You Forget Password :
6. While being asked of password, you just forget it and you must
access the system. The only way is to turn off system and clear
CMOS memory. Please take reference in page 27 for clear
CMOS setting.
