- 54 -
SDRAM Timing By SPD
This item allows you to enable or disable the SDRAM timing defined by
the Serial Presence Detect electrical
.
Ø
The choice: Enabled or Disabled .
SDRAM Frequency
This item determines frequency of SDRAM memory.
Ø
The choice: Auto, 100MHz, 133 MHz.
SDRAM CAS# Latency
This item determines the operation of SDRAM memory CAS (column
address strobe). It is recommended that you leave this item at the default
value. The 2T setting requires faster memory that specifically supports this
mode.
Ø
The choice: 3, 2.
SDRAM Bank Interleave
Enable this item to increase SDRAM memory speed. When enabled,
separate memory banks are set for odd and even addresses and the next
byte of memory can be accessed while the current byte is being refreshed
.
Ø
The choice: Enabled or Disabled .
AGP Mode
This item provides the OnBoard VGA mode with three options of 1,2, 4
multiplied frequency.
Ø
The choice: 4X, 2X, 1X .
AGP Comp. Driving
Use this item to signal driving current on AGP cards to auto or manual.
Some AGP cards need stronger than normal driving current in order to
operate. We recommend that you set this item to the default.
Ø
The choice: Auto or Manual .
Manual AGP Comp. Driving
When AGP Driving is set to Manual, use this item to set the AGP current
driving value.
Ø
The choice: Auto, Manual.
AGP Aperture Size
This item defines an AGP for the graphics. Leave this item at the default
value 64MB.
Ø
The choice: 4MB,8MB,16MB,32MB,64MB,128MB,256MB.
