209
a) Fitting the feet
•
Carefully place the heater upside down on a
level surface.
•
Screw each of the feet onto the unit with a
Phillips-type (cross-headed) screwdriver.
Use the screws supplied as illustrated.
b) Wall mounting
Take care when drilling the mounting holes
or tightening the screws that no cables or
pipes are damaged. If you are in doubt about
how or where to mount the heater, contact a qualified specialist.
When selecting a mounting location, take the length of the power cable into account. Do not use
any extension cable.
The screws and plugs provided are designed for solid walls. If you have another type of wall, use
screws and plugs appropriate for that type. If you are in doubt about this, contact a qualified
specialist.
The hook brackets are already mounted on the rear of the heater. To drill the holes for the plastic
plugs, use an 8-mm drill.
The heater must be mounted so that there is a
distance of at least 30 cm to the floor, to
adjacent walls and to the ceiling.
Use the drilling template provided to mark the position for the two upper holes. To ensure that
the mounting is perfectly horizontal, use a spirit level.
•
Drill two holes (Ø 8 mm) and insert the plugs.
•
Insert the screws such that they still protrude a little and the bracket can be hooked
on. The bracket must sit behind the head of the screw and not above its top edge.
30
cm
30
cm
