3. Measure the bracket to bracket width and verify it matches the width as ordered.
Remove the end caps.
1. Hold the wall bracket/end cap assembly against the wall and mark the hole locations.
2. Remove the end cap, fasten the bracket with the supplied screws, and replace the end cap.
NOTE: Nano manual shade brackets are intended to be wall mounted.
They may be ceiling mounted, but the appearance is degraded.
Installation - Nano Roll - Manual
Pg 7
NOTE: Make sure to leave
enough space for the end cap.
INSTALLATION –
Nano Roll – Manual Operation
Brackets must be
level before the
shade is installed!
