1.Environmental Protection and
Proper Disposal
Package materials
The appliance is packag ed in a way to prev ent damages
during transportation. Recyclable materials are used.
The packing box is made of corrugated board / cardboard
(mainly from recycled paper).
·
Polystyrene parts (CFC-free foamed polystyrene)
·
Linings and polyethylene bags
·
Polypropylene straps
All thes e va luable materi als ma y be take n to a waste
collecting center and used a gain after ade quate recycling.
All waste materials should be disposed properly.
2.Location
Make sure the refrigerator is kept uprig ht during han dling.
If an incl ination is r equired, it shou ld not e xceed 45
degrees. Other wise the a ppliance ma y get dama ged
resulting n ot onl y i n compromised refrigeration
performance.
To avoid product dama
ge or person
al injur y, the
refrigerator should be unpacked by two persons after it is
located in a previously selected position.
Before i nstallation, make su re the r efrigerator has no
visible exterior damage.
When handling the refriger ator, do not lift it by holding the
worktop, to prevent any damage to the refrigerator.
Do not start up a refrigerator that is damaged.
Check the refrigerator carefully for:
·Damaged package due to inappropriate handling
during transportation
Damage in the exterior
·Damage in power cord / plug
Any d oubt, please co ntact Customer Service for a
thorough checkup of the appliance.
Take necessar y me asures to prevent leakag
e of
refrigerant at the start-up of re frigerator that ma y result in
environmental pollution.
3.Installation
a) Remove all package materials.
b) Remove items in the refrigerator.
c) Make sure to remove film and tape on the cabinet and
the door.
d) Remov e polystyrene c hips (if a
ny) aroun d the
refrigerator.
e) Take out accessories and literature in the refrigerator.
f) Clean the inside of the refrigerator with luke warm
water and vinegar and then dry it with a soft cloth.
g) Use the spanners supplied to adjust the leveling leg to
ensure the refrigerator is stable.
Do not use detergents, sharp or pointed instruments
or soda-based cleansers to clean the refrigerator.
· Before installation, make sure the refrige ration s ystem
is free of any damage.
· The refrigerator should be used for its intended purpose
only.
· The refriger ator shoul d be position ed on the solid and
even floor to ensure refrigera
nt circul ation an d
refrigerating performance.
· If possibl e, positio n the re frigerator in a cool an d dr y
well ventilated room.
· Do not e xpose the refrig erator to direct sunshi ne a nd
make sure the ambient tem perature is not extremel y
high.
· Keep the refrigerat or from a heat sou
rce, such as
heating s ystem, oven or cookers. Ot herwise the
compressor will op erate mor e freque ntly resultin g in
extra power consumption.
If the refrigerator will be p laced near a h eat source, it is
recommended to install a t
hermal barrier bet ween the
refrigerator and the heat source (asbestos is prohibited) or
maintain adequate space between the refrigerator and
the heat source as follows:
Do not place a ny radiating apparatus, such as micro wave
oven or roaster, on top of the refrigerator.
Make sure the air vent is not obstructed.
Never unplug the refrigerator by pulling on the power cord.
Always grip the plug firmly and pull it straight out from the
outlet.
2
the heat source as follows:
Cooker or electric stove
3 cm
Radiator or oven
30 cm
Another refrigerator
2 cm
