e005 OLIMPO
ver. 00
User’s manual
pag. 5 di 29
Printed in
e005-di OLIMPO (eng).doc
Siap+Micros S.r.l.
Digit ‘S’ for 2 seconds to start setup procedures
Resetting procedures in action for the start up process
Press "S" for 2 seconds for start up process
Menù OLIMPO
14:55:17 29/08/2001
T=PR. TIME
A=RES. MEMORY
C=CONFIGURATION
HH MM SS GG MM AA =
2 The use of the Olimpo main unit
1.9 Switching on the Olimpo main unit
The Olimpo Main unit is switched on by pressing the switch situated at the front of the Main unit next to the
LCD display. The LCD light will immediately come on and after a few seconds the OLIMPO allows you to
enter the SETUP procedures by pressing the button indicated as "S" as written on the display:
If no letters are digited the Olimpo Main Unit will carry out the preset acquisition procedures.
1.10 Setup
At any moment of the acquisition cycle it is possible to have access to the SETUP module and layout the
variables of measurement and deal with them as described below, the meaning of these various layouts from
the configuration menu is shown below:
Press the button "S" which will appear on the display:
After a few seconds the wording "Press S for 2 seconds for SETUP" will appear:
Like this you have access to the menu for the SETUP module as indicated with the wording below:
1.10.1 Setting the clock
T = PR. ORA
: Menu to set the clock which is inside the main unit.
Digit the button "T" to have access to this menu and on the display will appear :
