Fig.9d
14. PICK-UP REPLACEMENT AND ADJUSTMENT
To replace the pick-ups, follow this procedure:
- Disconnect the connection of the pair of pickups from the MBUGRF board (D fig. 3);
- loosen the pick-up pre-load springs completely (A, Fig. 10);
Fig. 10
- Unscrew the two M10 dowels and replace the pick-ups (B, Fig. 10) with the new ones;
- assemble the new pair of pick-ups, ensuring that the spheres are correctly positioned inside the appropriate niches, and that the pick-up
marked with the letter I (internal) is assembled on the right and the one with the letter E (external) is on the left (assuming you will work from
in front of the machine);
- tighten the fixing dowels so that the pick-ups are slightly rubbed;
- tighten the locknuts as far as the blocking point, then unscrew them slightly (by about one side of the hexagon) so that the Belleville washers
are working.
Summary of Contents for S 64E
