Minimum
Typical
Maximum
FE screw terminal technical data
Rigid wire cross-circuit
0.3 mm²
1.6 mm²
Flexible wire cross-circuit
6)
0.3 mm²
1.6 mm²
American wire gage (AWG)
22
14
Wire stripping length
5 mm
Screw tightening torque
0.5 Nm
Screw terminal technical data
Rigid wire cross-circuit
0.14 mm²
1.5 mm²
Flexible wire cross-circuit
7)
0.14 mm²
1.0 mm²
American wire gage (AWG)
26
16
Wire stripping length
5 mm
Screw tightening torque
0.22 Nm
0.3 Nm
Cable length for power supply tolerance ± 10%
At wire cross-section 1 mm²
50 m
At wire cross-section 0.5 mm²
25 m
At wire cross-section 0.25 mm²
12 m
Cable length for power supply tolerance ± 5%
At wire cross-section 1 mm²
60 m
with a wire cross-section of 0.5 mm²
30 m
with a wire cross-section of 0.25 mm²
15 m
Cable length for power supply tolerance ± 1%
At wire cross-section 1 mm²
70 m
with a wire cross-section of 0.5 mm²
35 m
with a wire cross-section of 0.25 mm²
17 m
UNI-I/O1 and UNI-I/O2
Input resistance at HIGH
2 kΩ
Voltage for HIGH
11 V
24 V
30 V
Voltage for LOW
–3 V
0 V
5 V
Input capacitance
15 nF
Static input current
6 mA
15 mA
When used for Reset
Actuating time of the control switch
200 ms
When used for EDM
Permissible contactor dropout time
300 ms
Permissible contactor pull in time
300 ms
UNI-I/O3, UNI-I/O4 and UNI-I/O5
Switching voltage HIGH at 200 mA
U
V
– 3.3 V
U
V
Source switching current
100 mA
200 mA
Current limiting (after 5 ms at 25 °C)
600 mA
920 mA
Switch-on delay
1.4 ms
2 ms
Switch-off delay
0.7 ms
2 ms
Response time UNI<I/O3, UNI<I/O4 and
UNI<I/O5 on configuration as warning field out‐
put
Corresponds to the resulting response
time of the OSSDs plus 50 ms
12
TECHNICAL DATA
124
O P E R A T I N G I N S T R U C T I O N S | S300
8010948/ZA21/2020-06-18 | SICK
Subject to change without notice
