5
Mounting
5.1
Safety
DANGER
Dangerous state of the machine
b
Make sure that the dangerous state of the machine is and remains switched off
during mounting, electrical installation, and commissioning.
b
Make sure that the outputs of the safe multibeam scanner do not affect the
machine during mounting, electrical installation, and commissioning.
DANGER
Hazard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of
non-observance.
b
Do not do repair work on device components.
b
Do not make changes to or manipulate device components.
b
Apart from the procedures described in this document, the device components
must not be opened.
DANGER
Hazard due to lack of effectiveness of the protective device
If unsuitable brackets are used or if subjected to excessive vibrations, the device may
become detached or damaged.
Persons and parts of the body to be protected may not be recognized in case of
non-observance.
b
Only use SICK-approved brackets for mounting.
b
Take appropriate measures for vibration damping if vibration and shock specifica‐
tions exceed the values and test conditions specified in the data sheet.
NOTICE
The front screen of the safe multibeam scanner is an optical component.
b
Do not contaminate or scratch the front screen during unpacking and mounting.
b
Avoid fingerprints on the front screen.
5.2
Unpacking
Approach
b
Check components for completeness and integrity for all parts.
b
In the event of complaints, contact the responsible SICK subsidiary.
Further topics
•
5.3
Mounting the device
Overview
The safe multibeam scanner can be mounted on the machine either directly or with the
help of the optionally available alignment bracket.
MOUNTING
5
8025936/2021-01-08 | SICK
O P E R A T I N G I N S T R U C T I O N S | scanGrid2 I/O
37
Subject to change without notice
