2
Safety information
2.1
General safety notes
DANGER
If the safety component is integrated incorrectly, the dangerous state may be ended to
late.
b
Plan the integration of the safety component in accordance with the machine
requirements,
see "Project planning", page 16
.
Laser class 1
CAUTION
If you use different operating or adjusting equipment from the operating or adjustment
equipment specified in this document or if you carry out different procedures, this may
lead to dangerous radiation effects.
b
Only use the operating or adjusting equipment specified in this document.
b
Only carry out the procedures specified in this document.
b
Do not open the device.
LASER
1
Figure 1: Laser class 1
This device complies with the following standards:
•
IEC 60825-1:2014
•
21 CFR 1040.10 and 1040.11, except compliance with IEC 60825-1:2014, as
described in Laser Notice No. 56 dated 08.05.2019
The laser is eye-safe.
The laser marking is located on the back of the safe multibeam scanner.
2.2
Intended use
The safe multibeam scanner is an electro-sensitive protective device (ESPE) and is used
for object detection.
The safe multibeam scanner is suitable for the following applications:
•
Mobile hazardous area protection
•
Access protection
The safe multibeam scanner must only ever be used within the limits of the prescribed
and specified technical data and operating conditions.
Incorrect use, improper modification or manipulation of the safe multibeam scanner
will invalidate any warranty from SICK; in addition, any responsibility and liability of SICK
for damage and secondary damage caused by this is excluded.
2
SAFETY INFORMATION
8
O P E R A T I N G I N S T R U C T I O N S | scanGrid2 I/O
8025936/2021-01-08 | SICK
Subject to change without notice
