6
Mounting
6.1
Mounting instructions
•
Observe the technical data.
•
To prevent condensation, avoid exposing the device to rapid changes in tempera‐
ture.
•
The mounting site has to be designed for the weight of the device.
•
It should be mounted so that it is exposed to as little shock and vibration as possi‐
ble. Optional mounting accessories are available,
•
Protect the device from moisture, contamination, and damage.
•
Ensure a sufficient level of cooling using ambient air/convection and/or heat
dissipation through mechanical mounting. Observe the permitted operating tem‐
perature,
6.2
Required parts
You need the following parts to get started with Ruler3000:
•
Ruler3000 camera.
•
PC with a network interface card (NIC) that supports Gigabit Ethernet. For informa‐
tion about requirements,
"Recommended network card settings", page 113
.
•
Power I/O cable.
•
Ethernet cable for Gigabit Ethernet, with M12 connector for the camera.
•
24 Voltage supply.
•
Connection module, i.e. CDB650 or similar (optional).
6.3
Mounting the device
The camera and laser are mounted inside the device so that the laser illuminates the
object from one direction, and the camera views the object from another direction.
The height positioning of the Ruler depends on the maximum width and height of
the objects to be inspected. The wider the objects are, the higher the unit must be
positioned. When the Ruler3000 is turned on, the emitted laser line must always cover
the entire object width and should also extend a little on each side.
6
MOUNTING
26
O P E R A T I N G I N S T R U C T I O N S | Ruler3000
8026049//2021-04 | SICK
Subject to change without notice
