Chapter
4
Operating Instructions
CLV65x Bar Code Scanner
40
©
SICK AG · Division Auto Ident · Germany · All rights reserved
8011980/0000/2009-04-21
Product description
Use of the buttons
In order to use one of the possible function with the buttons, do as follows:
1. Press the upper button (
) for approx. 3 seconds.
The bar code scanner stops the current reading operation, switches off the LEDs and
the bargraph display and changes to the button operating mode. With immediate effect
the bar code scanner ignores all the other external reading pulses. No reading results
are displayed via the host interface.
The beeper confirms this process with an ascending melody.
The "Read Diagn" function is pre-selected as first function (LED flashes slowly).
2. Repeatedly press the lower button (
) until the LED of the required function flashes.
The bar code scanner scans all the possible functions successively without starting
them and starts over.
The beeper confirms each step with a sound.
3. Press the upper button (
) once to start the selected function.
The LED flashes faster and the beeper confirms the start with two sounds.
4. Press the upper button (
) again to stop the function.
The LED flashes more slowly again and the beeper confirms the end with two sounds.
The bar code scanner stops the "TeachIn" (for matchcode) and "Auto-Setup" function
automatically, when the presented bar code was read successfully. During this proce-
dure, the "Ready" LED flashes in green three times and the beeper confirms it with an
ascending melody.
5. In order to return from the button operating mode to the reading operation, press the
upper button (
) again for approx. 3 seconds.
The beeper confirms the change with a descending melody.
The "Ready" LED lights up again.
The bar code scanner is ready for reading and waits for a reading pulse.
Important
When using the Auto-Setup function, make sure that the bar code is in the maximum
readable distance to the bar code scanner.
