Technical Information
HC8X Heat Control
E-6
©
SICK AG · All rights reserved
8010043
Introduction
Introduction
This documents provides instructions for:
Mounting and electrical installation
Start-up and shut-down
Operation, configuration and parameter setting
Retrofitting and troubleshooting
This document contains information on:
Safety warnings and recommendations that must be followed to ensure safe operation
and to maintain the control unit in a safe condition.
Contact partners and intended use
Environment and compliance
Method of operation and design of the control unit
The HC8X heat control is referred to as "HC8X" in the following.
Target groups:
The target groups of this document are persons with electro-technical training.
Mounting, electrical installation, servicing and replacement:
Electricians and service technicians
Start-up, operation and configuration:
Technicians and engineers
Information depth:
This document contains all information required for mounting, electrical installation and
start-up of the HC8X with the
basic factory settings
.
All these activities are explained step by step.
The configuration of the HC8X for the
specific application usage
is performed with the
DOS 6.22-oriented HC8XINIT.EXE utility program or with the Windows-oriented
SETHC8X.EXE utility program.
The warnings and safety notices summarized on the following pages are intended to sup-
plement, not supersede, the safety regulations valid in the individual countries.
Before start-up of the control unit:
Carefully read and observe the safety notices and warnings contained in this manual as well
as the relevant chapters on installation, start-up and operation of the control unit.
Before starting to work, inform yourself about the relevant regulations for preventing acci-
dents issued by the professional associations, the legal stipulations (safety regulations con-
cerning hazardous substances) and the standards.
Always observe all warnings and safety notices in the Manual!
