Operating instructions
Chapter
8
ICR 84x Image Code Reader
Troubleshooting
8 010 961/0000/10-05-2005
©
SICK AG · Division Auto Ident · Germany · All rights reserved
8-15
8.5.6
Malfunctions: Errors when using the image outputting in reading mode
Prerequisite
The “Device Ready“ LED lights up. If not, see
.
8.6
SICK support
If a system error occurs repeatedly or if you cannot correct an error using the above
measures, the ICR may be defective. The ICR contains no user-serviceable parts.
Please contact our local SICK office or subsidary:
•
The telephone numbers and email addresses are listed on the
back page
of
this manual.
For postal addresses see also
www.sick.com
.
¾
Do not send the device to the SICK service without first contacting us.
Fault
Possible cause
Remedy
ImageFTP does not display the contents of
the ICR image memory.
•
The ICR is not triggered
•
Image acquisition parameterized
incorrectly in the ICR
•
Ethernet connection:
The PC (server) has an incorrect
FTP address
•
Ethernet connection:
The ICR has not been defined as an FTP
client
•
ImageFTP: the server has been stopped
or the image has been frozen
•
The evaluation range in the image
memory was incorrectly limited
•
Trigger the ICR accordingly.
•
Check in the CLV Setup program:
Select the I
MAGE
A
CQUISITION
tab and find
the A
CQUISITION
group: output activated?
If condition is selected, does this occur
during the read process?
I
MAGE
FORMAT
group: is at least one image
type selected?
•
Check in the CLV Setup program:
Select the E
THERNET
tab and find the
S
ERVER
ADDRESS
group: enter the
address. This must not be the same as
the TCP/IP address.
•
E
THERNET
tab, FTP-C
LIENT
group: active?
•
In the program window, restart the server
or unlock the current image
•
see
Table 8-10: Troubleshooting: Errors when using the image transfer via the Ethernet interface
