Operating Instructions
Batch Scanning (Inventory Mode)
IDM corded & IDM Bluetooth
8017159/142O/2019-05-23
© SICK AG · Germany · All rights reserved · Subject to change without notice
25
2.8.3
Transmit stored data
The scanner is preset to transmit all the stored data by scanning the “Transmit Stored Data” command.
During the transmission, the scanner will emit continuous short clicks and the link indicator will blink blue.
Then the scanner will give two short beeps after data transmission is completed.
Transmit stored data
You are still able to set the scanner to transmit the stored data by placing the scanner onto the cradle as well.
Scan Barcode Command
Place scanner onto the cradle
Scan command or place scanner onto the cradle
2.8.4
Delete data
If a wrong barcode was scanned, the “Delete Last Scanned Data’’ command is helpful to recover mistakes. By
scanning the ‘’Delete Last Scanned Data’’ command, the last stored data can be deleted.
Delete last scanned data
The scanner is preset to keep all the stored data until you scan the “Clear All Stored Data” command.
However you are also able to change the setting to “Auto Delete Stored Data after transmission”. (Refer to
chapter 3.10.3)
Clear all Stored Data
