Chapter
2
Operating Instructions
Laser measurement sensor LD-MRS
10
©
SICK AG · Germany · All rights reserved · Subject to change without notice
8012948/ZMQ0/2017-06-09
For your safety
In design and production, established technological rules have been applied and observed.
Development and production in SICK AG ensure this quality standard by a certified quality
management system according to EN ISO 9001:2008.
If the user adheres to all safety notes in this operating instructions and uses the device as
intended, he is sufficiently protected.
2.2
Authorized personnel
The LD-MRS must be mounted and operated by qualified personnel to ensure its proper and
safe function.
Important
Only trained and authorized service personnel of SICK AG may repair the LD-MRS.
The different tasks require the following qualification:
Activities
Qualification
Mounting, maintenance
– practical technical basic training
– knowledge of the established safety rules at work
Electrical installation,
device replacement
– practical electrical training
– knowledge of the established electric safety rules
Commissioning, configura-
tion
– basic knowledge of Windows
TM
in the version used on site
– basic knowledge of data transmission
– Basic knowledge of how to establish and set up (address) Ethernet
connections when connecting the LD-MRS to the Ethernet
– Basic knowledge of how to establish and set up a CAN network
when using field monitoring
Processing the measured
values in EDP systems
– Programming skills for the application to be created in measuring
mode
Tab. 2-1: Required qualification for commissioning the LD-MRS
