Chapter
1
Operating Instructions
Laser measurement sensor LD-MRS
8
©
SICK AG · Germany · All rights reserved · Subject to change without notice
8012948/ZMQ0/2017-06-09
About this document
1
About this document
1.1
Function
This document informs technical personnel how to safely install and operate these versions
of the LD-MRS laser measurement sensor:
•
LD-MRS400001 (standard version)
•
LD-MRS400102 (heavy duty version)
•
LD-MRS420201 (UAV-Version with light housing)
•
LD-MRS800001 (standard version with 8 layers)
The document contains information about
•
Mounting and electrical installation
•
Commissioning and configuration (parametrization)
•
Maintenance
•
Troubleshooting
•
Replacing the laser measurement sensor
Important
In the following, the LD-MRS400001, LD-MRS400102, LD-MRS420201 and LD-
MRS800001 laser measurement sensors are termed "LD-MRS" for short, except in cases
where differences need to be explained specifically.
1.2
Target group
The target group of this document are people in the following positions:
1.3
Depth of information
This document contains all information required for mounting, electrical installation and
commissioning of the LD-MRS with
factory settings
.
All tasks are described step by step.
The configuration of the LD-MRS for user-specific situations in
measuring mode
as well as
measurement queries for displaying the scan data are done via the provided visualization
tool SICK LaserView Customer Edition or with messages. The LaserView software is also
used to configure the object data. Further Information is available in the corresponding do-
cument Article no. 8013787.
To configure
field monitoring,
use the SOPAS-ET configuration software. SOPAS-ET can also
display scanning data from measuring mode.
Further information about laser measurement technology is available from SICK AG, Divi-
sion Auto Ident, and on the internet at
www.sick.com
.
1.4
Symbology used
Some information in this documentation are highlighted to facilitate quick access to these
information:
Activities
Target group
Mounting, electrical installation, main-
tenance, replacement
Qualified personnel, e.g. service technicians, factory
electricians
Commissioning, configuration
Qualified personnel, e.g. technicians, engineers
Tab. 1-1: Target group