4.
Remove the device from the bracket.
5.
Backed-up configuration data: if an optional microSD memory card is installed in
the device, remove the memory card with the backed-up parameter set.
Putting the replacement device into operation:
1.
Backed-up configuration data: install the optional microSD memory card from the
device that is to be replaced in the replacement device of the same type.
2.
Mount and align the replacement device (
). When doing
so, note the previously applied markings on the bracket or surroundings.
3.
Reconnect the connecting cables of the replacement device (
4.
Switch on the supply voltage for the replacement device.
✓
The device starts with its last permanently saved parameter set. In the case of
devices that have not been used before, this corresponds to the factory default
setting.
✓
The device searches for external storage media with a valid parameter set.
Depending on the success of the search, the replacement device proceeds as
follows:
°
When the replacement device detects an external storage medium, the
replacement device automatically transfers the configuration data to the
permanent device memory.
°
If the replacement device does not detect any external storage media, the
replacement device will start with its last permanently stored parameter set.
In the case of devices that have not been used before, this corresponds to
the factory default setting.
5.
Establish a connection with the replacement device using the SOPAS ET configura‐
tion software.
6.
Optional: transfer the configuration data of the device to be replaced by download‐
ing to the replacement device and permanently store this data in the device.
TROUBLESHOOTING
9
8018071/1E1C/2021-12-16 | SICK
O P E R A T I N G I N S T R U C T I O N S | Lector63x Flex C-mount and S-mount
63
Subject to change without notice
