6
COMMISSIONING
134
8017768/12AX/2019-05-31|SICK
O P E R A T I N G I N S T R U C T I O N S | TIC
Subject to change without notice
6.8
Checking that measuring mode is working properly
Finish commissioning the system by performing a test run. The test run must make sure
that the system components are working correctly and that they are delivering plausible
measured values.
The test run can only be performed if the site configuration process has been successfully
completed and all of the system functions and system components in the navigation tree
have a green square next to them.
6.8.1
Displaying vehicles with measured values
Whenever TEMS Manager is connected to the TEMS Recorder, the
Vehicles
workspace
contains a table of the last 50 vehicles recorded (or vehicles with a maximum memory of
50 MB). The order in which the vehicles are displayed depends on the column selected
and the sorting setting.
The display shows the time of the recording, the detected vehicle category together with a
pictogram, the lane, the speed, and the vehicle dimensions.
Changing the number of vehicles displayed
By default, ten vehicles are displayed per page.
▸
To change this, go to the
Entries per Page
field underneath the table and enter the
desired number (in increments of five). The maximum number of vehicles that can be
displayed in the table is 25.
▸
You can use the search field to filter the list of vehicles on the page. Enter a character
string. The list is automatically narrowed down so that only those vehicles with a
matching character string in one of the columns remain.
