Figure 54: Editing fields using coordinates
The reference points for the X and Y values are as follows:
•
Rectangle: top left corner
•
Circle: center point
•
Circle sector: center point
•
Polygon: each point individually
•
Contour line: each point individually
7.9.7
Drawing in points that cannot be monitored
The area to be monitored is scanned radially
1
. For this reason, shadows
3
are
formed by objects in the room
2
(support columns, separator grids, etc.). The safety
laser scanner cannot monitor these areas.
7
CONFIGURATION
86
O P E R A T I N G I N S T R U C T I O N S | microScan3 Core I/O AIDA
8017784/1ELL/2022-01-21 | SICK
Subject to change without notice
