NOTE
The drag & drop Logic Editor configuration is not accessible via the fieldbus or the REST
API. There, only process data can be used as input or output values for the Logic Editor.
The Logic Editor can use all available signal inputs as sources for the logic application.
In SIG200 this includes:
•
All IO-Link port pins configured as “Digital Input”
•
IO-Link Process Data In from all SX port pins 4 configured to IO-Link mode (Port
S1-S4)
•
Fieldbus Input Process Data
•
REST API Input values
NOTE
It is necessary to upload and assign the IODDs of the devices to be used in the Logic
Editor.
Removing IODDs of devices which has been connected in the Logic Editor could lead to
incompatibilities. This is indicated by the following notification:
Editing Mode
Figure 22: Editing Mode
1.
To start your configuration change the operating mode from
Run
to
Maintenance
because the
Run
mode is a read only mode.
2.
Click on
Run
on the bottom left side and select
Maintenance
in the drop-down menu.
3.
The login password for the maintenance mode is:
main
4.
Click on
Login
to select the Maintenance Mode.
DEVICE FUNCTIONS
8
8017853.1D0S/2021-11-04 | SICK
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
103
Subject to change without notice