NOTE
Processing of the process data in the logic editor is not permanently clocked. That is why, depending on the load of
the device, e.g. due to increased network load, there may be a delay in the output process data.
NOTE
If IO-Link pin 4 changes from SIO mode to IO-Link mode the signal output shall be deactivated (and vice versa).
Inputs
Digital:
The pin 2 of Ports S1-S4 can be individually used. All pin 2 boxes are visualized by default in the logic editor. In
case a port has been configured as “Digital Input” meaning pin 4, it will be shown on the left side as an input.
Analog:
The constant number block can be set to a fixed value to be used for further processing.
Rest:
It is possible to set an input value via REST to be processed by the logic configuration of the SIG200. This input will
be visualized with "Rest In" on the logic editor page.
Profinet:
The Profinet output block allows the injection of process data from the PLC to the logic which appear as inputs in
the workspace.
Outputs
Digital:
8
DEVICE FUNCTIONS
110
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
8017853.1D0S/2021-11-04 | SICK
Subject to change without notice