Figure 13: Status page
The page displays the parameterization of pin 2 (DI) and pin 4 (C/DI/DO) for each port.
The LEDs in the SIG200 figure change their state depending on the current state of the
connected device. The ports correspond to the IO link, input or output settings defined
on the
CONFIGURATION
(parameterization) page. The port designations correspond to the
user-defined port designations defined on the
CONFIGURATION
(parameterization) page.
The
POWER
LED shown in the figure on the left is normally always green to indicate that
the SIG200 is switched on.
The
BF
(bus error) LED indicates when there is an error in the PROFINET interface.
The
SF
(system error) LED indicates when there is a system error.
ACT/LINK1 + 2 indicate if there is Ethernet network connection on either port.
NOTE
Note that the LED displays do not work in real time. When the SIG200 is started for the
first time, the device has an initialization time after switching on of approx. 70 seconds
7.3.4
IDENTIFICATION
page
The
IDENTIFICATION
page provides detailed information about the connected SIG200.
These include the product name, serial number and firmware version.
7
SIG200 CONFIGURATION
50
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
8017853.1D0S/2021-11-04 | SICK
Subject to change without notice