Figure 15:
CONFIGURATION
page, gateway
NOTE
If the Ethernet settings are changed, device communication may be interrupted.
NOTE
A device power cycle is necessary to activate the ethernet parameter changes.
7.3.5.2
PROFINET settings
This tab provides several possibilities to configure the structure and size of process
data to be exchanged between the PLC and the Logic Editor.
The expected input and output size matches the Logic Editor submodule 2 in slot 1
from the PROFINET configuration stored in the SIG200. In order to guarantee correct
process data transfer, the expected size should correspond to the selection.
The structure of the process data can be adjusted according to the application and
logic by changing the Input and Output Data Configuration. This is important in terms of
handling differnet data types in the logic editor.
The input and output data can be labled individually to achieve a clearer wiring in the
Logic Editor.
7
SIG200 CONFIGURATION
52
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
8017853.1D0S/2021-11-04 | SICK
Subject to change without notice