25
8015383/ZUQ7/V1-3/2020-06 | SICK
O P E R A T I N G I N S T R U C T I O N S | TRANSIC151LP
Subject to change without notice
INSTALLATION
3
3.4.4
TRANSIC151LP installation - ambient gas measurements
Installation Instructions
Fig. 9: TRANSIC151LP, fitted on a wall
1
Fit the wall bracket to the 4 drill holes.
2
Fasten the TRANSIC151LP to the wall with the four M6 screws.
3
Tighten the four screws.
4
2
3
5
6
1
7
1 = Stainless steel mesh filter
2 = External grounding connection
3 = Calibration gas inlet with a Ø 6 mm Swagelok connection (optional)
4 = M20 × 1.5 cable gland for supply and signal lines
5 = Max. screw size M6
6 = Wall bracket
7 = Device screws
First fix both outer screws in the threads at the bottom of the TRANSIC151LP. This
simplifies fastening the two inner screws when positioning the TRANSIC151LP on the
wall bracket.
Dimensions and drill holes for the wall bracket,
.
Ensure the TRANSIC151LP is installed in a representative gas mixture.
