▶
Digital inputs: D-IN0 = no function
If the control channel (and setpoint channel up to version 3.08) is not set to “Serial
interface / RS485 / USB”, an error message will be triggered when you select the desired
function. The settings in the
drivemaster2
software are described in
In addition, the remote bit in the status word must be set by the firmware.
Note
All functions of the terminal are only available if you have set the parameters as de-
scribed above. Otherwise, you will not be able to start the motor via the operating termi-
nal.
The display of the actual values is always active.
Via the START key, you can switch on the output stage. The spindle will then rotate
at the preset speed.
With software version (operating terminal) 3.17 or higher, switch-on is a multi-stage
process. According to the terminal status, you must press the START key repeated-
ly: Ready for operation (output stage off) → Switched on (output stage on, holding
current) → Operation enabled (spindle rotates)
Via the STOP key, you can stop the spindle and the output stage will be switched off.
With software version (operating terminal) 3.17 and higher, switch-off is a multi-
stage process. According to the terminal status, you must press the STOP key re-
peatedly: Operation enabled (spindle rotates) → Switched on (output stage on, hold-
ing current) → Ready for operation (output stage off)
Once the output stage has been switched off, you can change to the MAIN MENU
via the ESC key.
Via the “Cursor up” and “Cursor down” keys, you can access the speed settings.
Here, you can modifiy the actual reference speed. For more information, refer to
chapter 14.3.2.1 “Change parameters”, page 31
. You can modify the speed in the
parameter menu regardless of the user privileges.
14.3
PROGRAM MENU
In the PROGRAM MENU, you can access the parameter menu, read and write parame-
ters, delete the terminal memory and access the password administration.
Via the “Cursor up” and “Cursor down” keys, you can select the different menu
items.
When you press the ENTER key, the display will switch to the selected menu.
When you press the ESC key, the display will return to the MAIN MENU.
29
Drive System SD2x - Operating Terminal 0362150 and 0362153
Functions of the Terminal
