Functions of the Terminal
14.3.6
WRITE PARAMETER
Note
You must enter the correct password to open this menu item.
Before writing the parameters, you are asked whether the parameters should be over-
written by the parameters stored in the operating terminal.
Press the ESC key if you want to deny the inquiry (“no”). In this case, the parameters
will not be written to the drive and the display will switch back to the AUTOMATIC
MODE.
Press ENTER if you want to confirm the inquiry (“yes”). In this case, the parameters
will be written to the drive. In a next step, there is a change-over in the drive, which
can take some seconds.
When the parameters are written, all parameter sets saved in the Flash EPROM of
the operating terminal are loaded into the Flash EPROM of the drive. The terminal dis-
plays the currently loaded parameter page, so you can follow the download progress:
Upon successful writing, the following message will be displayed:
If there is an error during writing, the process will be canceled and the following error
message will appear:
If thera are no parameters stored in the operating terminal or the drive is in BIOS
mode, the parameters cannot be written to the drive. The following message will ap-
pear:
34
Drive System SD2x - Operating Terminal 0362150 and 0362153
