47
Re-installation:
1.
Ensure that the nozzle of the water valve points downwards and that the groove
on the body of the water valve is aligned with the groove on the opening of the
dispenser moulding. Place the water valve in proper position by pushing it
downwards at an angle of 45
0
until it locks.
1
Groove
2
Nozzle
3
Opening on moulding
4
Moulding
2.
Install the seal ring on the bottom of the container.
Ensure that no creases or wrinkles occur.
3.
Install the water container on the door. Ensure that the
seal ring has been inserted into the water valve before.
Hold both sides of the water container tightly and
install the container at an angle of 45
0
.