4
AEROMAT 150
Installation and operating instructions
Last update: 08.2014
Important information
Please read the following instructions carefully before operating the unit for the first time.
Intended use
•
The AEROMAT 150 is intended for installation in the exterior windows/walls of permanent structures in accordance with
our installation and design documents as well as the specifications of our installation instructions and is only suitable for
the ventilation of enclosed rooms.
•
The unit must always be installed by an experienced specialist, in accordance with the installation and planning
documents of SIEGENIA.
•
Do not use the AEROMAT 150 in environments with corrosive or explosive atmospheres (dust, vapour or gas).
•
If the AEROMAT 150 is to be used in a room with a heating unit that draws air from the room, prior authorisation must be
obtained from the proper authorities, such as the officially appointed district chimney sweep. Intended use requires that
any combustion air lines and exhaust gas systems of solid fuel heating units must be able to be shut off.
•
Only operate and/or store the AEROMAT 150 at temperatures between -15 °C and +40 °C.
•
Use the AEROMAT 150 only with genuine accessories from SIEGENIA.
•
Use the AEROMAT 150 only when it is in a technically sound condition. Do not modify the unit's components in any way.
•
Ventilation openings must be kept free and must not be blocked by other equipment, furniture or objects.
•
In the event of a fault, only have the AEROMAT 150 repaired by experienced specialists with training and practice in the
repair of ventilation units.
•
Any use of this product that is not in accordance with its intended use, or any adaptation of or modification to the product
and its associated components for which the express consent of SIEGENIA has not been obtained, is strictly prohibited.
SIEGENIA accepts no liability whatsoever for any material losses or injury to people caused by failure to comply with this
stipulation.
Safety notices
Type AW 4 and Type DK
•
The unit should not be operated by people (including children) with physical, sensory or mental disabilities, nor by
people with insufficient experience or without previous knowledge, unless adequate supervision is provided or detailed
instructions on how to use the unit are issued by a responsible person.
•
If the network connection cable is damaged, it may only be replaced by SIEGENIA, its customer service department or a
qualified electrician.
•
Work on a 230-V AC mains power supply may only be performed by a qualified electrician.
•
All work on the 230 V AC mains power supply must be carried out in compliance with the current German VDE
regulations (e.g. VDE 0100) and any relevant country-specific requirements.
•
All-pole safety isolation should be used when fitting the network connection cable on-site.
•
Observe the numbering of the connecting cable.
- Swapping the leads may result in damage to the control electronics.
•
Fire hazard and risk of an electrical shock (for type AW4)!
•
Should a solid object or any liquid get inside the unit, stop operation immediately and disconnect the AEROMAT 150
from the mains power supply:
- Check whether the AEROMAT 150 has become damaged
- Have the unit repaired by a specialist, if necessary
